Assembled 29-Spline 3rd Members for Toyota 8" Axles

SKU:
304113-1-KIT
$975.00
TOYOTA
Pickup
4Runner
Category: 
DRIVETRAIN
Standard

Assembled 29-Spline 3rd Members for Toyota 8" Axles

Fully built 29-Spline 3rd members using all new parts and ready to drop into your 8" Toyota axle. Third members feature top quality high-strength 29-spline ring & pinion gears and your choice of lockers. V6 units feature larger OEM style V6 gear sets with longer pinion gear. Each unit is setup with solid pinion spacers for long gear life. Trail-Safe 29-spline pinion seal provided at no extra charge. Quadruple-drilled flange covers most Pickup/4Runner and Tacoma driveshaft patterns.

 

Housing Ratio Spool Detroit ARB Grizzly Zip
4Cyl 4.88 304113-1-KIT 304115-1-KIT 304117-1-KIT 304119-1-KIT 304121-1-KIT
4Cyl 5.29 304114-1-KIT 304116-1-KIT 304118-1-KIT 304120-1-KIT 304122-1-KIT
V6 4.88 304098-1-KIT 304100-1-KIT 304102-1-KIT 304104-1-KIT 304106-1-KIT
V6 5.29 304099-1-KIT 304101-1-KIT 304103-1-KIT 304105-1-KIT 304107-1-KIT
High Pinion 4.88 --- 304511-1-KIT 304513-1-KIT 304515-1-KIT 304517-1-KIT
High Pinion 5.29 --- 304512-1-KIT 304514-1-KIT 304516-1-KIT 304518-1-KIT

 

Application Notes: High Pinion units should only be used in front axle applications. Use in the rear axle will lead to ring and pinion failure. Spool lockers should only be used in rear applications. Spools will be harder on axles than a selectable or automatic locker. Fully built 3rd members will not fit stock Tacoma or T100 axles.

RING & PINION BREAK-IN PROCEDURE

All new 3rd members require a break-in period to prevent damage from overheating. Any overloading or over-heating during this periods can cause the gear oil to break down resulting in ring & pinion failure.

  • After installation drive lightly for 20-30 minutes and then allow the diff to cool for at least two hours.
  • Avoid heavy throttle use during the first 500 miles.
  • Do not tow a trailer during the first 500 miles.
  • Change oil after 500 miles to remove any particles suspended in the oil.

This may seem unnecessary but it is very easy to damage the differential by loading it before the gear set is completely run in. New ring & pinion gears create excess heat when they are new. This excess heat can damage the heat treatment of the gears. are new. This excess heat can damage the heat treatment of the gears.

Application Data:

  • 1979-1985 Toyota Pickup 
  • 1986-1995 Toyota Pickup (Rear axle only)
  • 1984-1985 Toyota 4Runner
  • 1986-1995 Toyota 4Runner (Rear axle only)

Note: Fully-built 3rd members will not fit stock Tacoma or T100 axles. Will not fit 7.5” IFS front axles.